FITTING GUIDE
			TheWON Crane Processor Kit will fit on nearly all existing cranes including the following manufactures cranes: Showman Cranes Guang Shing Dolphin Challenger Teddy Clark Elaut Mega Elaut Topper Elaut Jumbo Elaut Intelligrab Fantasy World Instance Comptons Harry Levy Mammoth Cranes Ice Controllers If you have a question about your crane, please no hesitate to contact us: EMAIL: sales@thewon.co.uk TELEPHONE: 0800 0433351
			Fitting the Kit Fitting time approx 15-20 minutes (1 minute for intelligrab cranes) All parts included in the kit Calibration and Configuration utilities on hand controller
			5 STEP GUIDE TO FITTING
			Step 1 - Fitting Beam Detectors Place the beam detectors either side of the payout chute, so that any toy falling down can be detected by the system.  The Receiver unit (the one with the black cable attached) should be faced into the crane to avoid interference from external light sources.  Peel off the protective backing from the double sided tape and fix to the side of the payout chute.  It is recommended that the beam detector is also fixed with the screws included.   Connect beam link lead and secure all cables with clips supplied. Once placed on either side, thread the cable into the back of the machine. There is often gap to push the connector through, if not drill a 10mm hole.
			Step 2 - The main system box Place the main system box in the back or bottom of the crane. Once installed you will not need to access the box again, so you may secure it safely.  If the system box is not easily accessible then connect the hand controller extension cable and route this to a suitable location (normally near the coin mech)
			Step 3 - Connect the crane grab Take the grab connecting cable and connect the jumper board between the existing crane control electronics and the gantry cable
			Step 4 - Connect Mains power Plug in TheWon system box to a suitable 240V power outlet or join power lead to existing mains cabling.
			Setup system using hand controller In 4 simple steps, use the hand controller to set the toy size, plays per toy, minimum grab strength and the amount of tease required. Then set the crane into learn mode, so that the system may learn the new toy.